Hood service divides into two things: the electrical parts and the airflow. Electrically there is a blower motor, a speed control or control board, lights and their sockets, and on newer models a link to the cooktop. Mechanically there is the filter, the ducting, the backdraft damper and the termination cap outside – and it is usually that side of things that causes the it does not extract properly complaint.
We measure what the blower is actually doing, inspect the duct route as far as it can be seen, check the damper, and only then look at the motor and control. If the hood is part of a downdraft or island installation, the duct run and the damper get extra attention because those installations are far less forgiving of restriction.
Common Range Hood Problems
Blower running but pulling very little air
Motor humming, rattling or vibrating at high speed
One or both lights out, or flickering
Controls not changing speed, or dead entirely
Backdraft damper rattling in the wind
Grease dripping from the filter area onto the cooktop
Popular GE Range Hood Models
GE JVW5301SJSS Wall-Mount Chimney Hood
Model # JVW5301SJSS
GE JVX5305SJSS Under-Cabinet Hood
Model # JVX5305SJSS
GE UVW9301SLSS Designer Wall-Mount Hood
Model # UVW9301SLSS
Why Trust Us With Your GE Range Hood
- Tested, Not Guessed | We test the suspected range hood part before recommending that anything is replaced.
- Parts for Popular Models | Commonly needed range hood parts travel with our technicians; less common parts are ordered and the return visit is scheduled before we leave.
- Safety First | Power, water and gas are isolated before we work on your range hood, and high-voltage and refrigerant work is handled only by the technician.
- Warranty-Aware Advice | If your range hood may still be under manufacturer coverage we tell you, because a repair by anyone other than an authorized technician can put that coverage at risk.